ProBoat Endeavor EP Spezifikationen

SpecificationsLength (Hull):24 in (610mm)Height (Mast):36.5 in (927mm)Beam:6.25 in (158.75mm)Radio:Spektrum DX2M 2.4GHzMotor:380-sizeSail area:Overall

10Section 6 – Checking the Radio SystemTurn on the radio system and test it to make certain it is functioning correctly. First, turn on the transmitte

11The following will help you get started in sailing. Follow the instructions and understand it takes some practice to become an accomplished yachtsma

12Section 7 – Sailing TipsSTARBOARD TACKPORT TACKSTARTPort Tack—Close-HauledSails: Keeping pulled inRudder: To be held at the center as long as the

13After you have finished rigging the sails, it will be helpful to trim the sails in order to optimize the performance of your boat. It is often neces

14 3. With the radio system on, move the left stick of your transmitter "down" to close the sails. The sails should close, with the jib sai

15Plastic PartsMasthead CraneSpreaderCleatEye PlateRigging Line GrommetBoom PlugMast HolderGooseneckBoom PivotJib StayMast Joiner

16Beam ReachSailing at approximately 90 degrees to the wind source with the wind coming from abeam.BeatingSailing toward the wind source or against th

17Diagram of Sailboat Rigging65.35 in [1660mm]42.5 in [1080mm]42.5 in [1080mm]11 in [280mm]22.83 in [580mm]9.84 in [250mm]19.68 in [500mm]49.25 in [12

18Warranty and Repair PolicyWarranty Period:Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the "Produ

19RMA number are clearly written on the outside of the shipping carton.Notice: Do not ship batteries to Horizon. If you have any issue with a battery,

Additional Safety Precautions and WarningsAs the user of this product, you are solely responsible for operating in a manner that does not endanger you

© 2011, Horizon Hobby, Inc.www.horizonhobby.com®Printed 01/2011 15242.1

3IntroductionThank you for purchasing the Pro Boat® Endeavor™ EP ready-to-run sailboat. This craft has been designed to provide many hours of scale sa

4 1. Assemble the boat stand as shown and use a wood glue or CA hobby glue to bond the pieces together. Place the hull on the stand. 2. Slide the up

5 5. Locate the main sail boom. Slide the screw through the eyelet and use a Phillips screwdriver to secure the end of the boom. Do not over tighten

6 8. Carefully unwrap the top, side rigging lines. 9. Insert the side rigging line into the outer hole in the spreader as shown.Note: The spreader h

7 13. Locate the jib sail boom. The end of the jib boom with the cleat should be on the top and nearest the front of the boat. Pass the rigging line

8 1. Locate one main sail luft ring. Open the ring and insert the small loop of the ring through the eyelet in the main sail. 2. Snap the luft ring

9 1. Locate the jib stay on rigging lines "C" and "D" on either side of the boat. Pull up carefully on the jib stay to adjust the